RE: [hobbit] curves went to zero but didn't have a report?

["Andrew Chen" <Andrew.Chen (at) ehealth-china.com>]

Hi Hubbard,

        Thanks for your reply.  I have checked the conn, it  only stopped 10m(13:45~13:55).  I  want to know if the hobbit can check the server’s CPU and Memory when they Zero. If I can recevie some email from hobbit. So I first know it. Can you give me some advice for hobbit setting? I am learning hobbit:-)

________________________________

From: Hubbard, Greg L [mailto:greg.hubbard (at) eds.com] 
Sent: 2008年6月24日 21:26
To: hobbit (at) hswn.dk
Subject: RE: [hobbit] curves went to zero but didn't have a report?

 

Looking at this graph, there is always some memory utilization and some CPU utilization (seen via load average).  I think the real problem is that something went wrong with the agent on this machine, or it could no longer communicate with the Hobbit server during this time period. You should review the alert history for this node and then make sure that you configure alerts appropriately.  I suspect that you will find that all of the agent-based tests went "purple" at about 1:30.  The other thing to check is the "conn" column -- if the system was not reachable, then the purple alarms for the agent-based tests would have been suppressed in favor of the reachability alarm.

	 

	
________________________________


	From: Andrew Chen [mailto:Andrew.Chen (at) ehealth-china.com] 
	Sent: Tuesday, June 24, 2008 3:17 AM
	To: hobbit (at) hswn.dk
	Subject: [hobbit] curves went to zero but didn't have a report?

	Let’s take a look at the CPU and Memory charts for this machine:

	At around 01:00pm, the curves went to zero.

	 

	 

	 

	 

	 

	   Above, the cpu and memory used 0, but I didn’t recevie a RED Alert report and email. (if there is some mothed to check this problem).

	Hobbit-client configured file

	   UP 1h 22w

	   LOAD 5.0 15.0

	   DISK / 80 90

	   DISK /boot 80 90

	   DISK /var 80 90

	 DISK /data 80 90

	   MEMSWAP 40 60

	   MEMACT 80 90

	 MEMPHYS 101 101

	This configuration only reported when the cpu and memory reach 5.0(cpu) and 80(memory), then they will send a alert report and email. But I can’t find about cpu and memory used 0, then send an alert report and email. Can you teach me how to do it? Thanks.