[Xymon] 4.3.24 tests not clearing once disable expiration is reached

[Larry Bonham]

I just noticed in 4.3.24 (RHEL 6.7) that a few monitors are not getting enabled once the disable expiration time is reached.

All the "normal" tests seem to work fine.  This is an environmental sensor device that is accessed with snmptraps and snmpgets for data retrieval.  That is all functioning as it should.

But when any of these particular tests are disabled (e.g. DC_Door_Alarm.ups) for a set time, they are now not getting enabled when the expiration time has been reached.  They just remain blue.  I did verify that the expiration time stamps are correct.

So I'm assuming the problem is triggered due to the way the hosts.cfg entries are set up.  Previous version used was 4.3.21 and disable expiration was working with it.

Example from hosts.cfg

# Data center facilities sensor
10.10.10.10    Sensor9
0.0.0.0             DC_Door_Alarm # noconn main side ups
0.0.0.0             DC_VESDA # noconn fault prealarm fire
0.0.0.0             DC_Fans # noconn fans
=========================================================

Larry D. Bonham

=========================================================


________________________________

CONFIDENTIALITY NOTICE:
This electronic mail message is intended exclusively for
recipient to which it is addressed. The contents of this message
and any attachments may contain confidential and privileged
information. Any unauthorized review, use, print, storage, copy,
disclosure or distribution is strictly prohibited. If you have
received this message in error, please advise the sender
immediately by replying to the message's sender and delete all
copies of this message and its attachments without disclosing
the contents to anyone, or using the contents for any purpose.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.xymon.com/pipermail/xymon/attachments/20160210/b74186aa/attachment.html>