[hobbit] rrd-data.log

[Henrik Stoerner]

On Wed, Aug 02, 2006 at 01:50:28PM +0200, Beau Olivier wrote:
> Hi,
> 
> yes, this is interesting, and i think it points out a new problem, 802.1q on nics :
>
> eth1      Link encap:Ethernet  HWaddr 00:0D:9D:4E:11:9C  
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:2798842 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:8950695 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000 
>           RX bytes:217776970 (207.6 MiB)  TX bytes:4275403340 (3.9 GiB)
>           Interrupt:201 
> 
> eth1.9    Link encap:Ethernet  HWaddr 00:0D:9D:4E:11:9C  
>           inet addr:192.168.250.33  Bcast:192.168.250.0  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:2226941 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:3441485 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0 
>           RX bytes:520111630 (496.0 MiB)  TX bytes:410431496 (391.4 MiB)

Perhaps, but these data should not get anywhere near the code that
prints out this message. The code that generates that message is
the one that parses the output from "netstat -s" which should look like

Ip:
    3017099 total packets received
    1 with invalid addresses
    0 forwarded
    0 incoming packets discarded
    3017058 incoming packets delivered
    3154813 requests sent out
Icmp:
    51081 ICMP messages received
    0 input ICMP message failed.

What does this command report on your host?


Regards,
Henrik