[Xymon] Error trying to configure xymon 4.3.10 in local mode on solaris 10

[Jeremy Laidman]

You seem to have $XYMONHOME defined as "." rather than the full path to the
directory.

On 13 September 2012 22:52, Kemi Ariyo <kemi.ariyo at issolutions.co.uk> wrote:

>  Hello,****
>
> I am trying to configure my xymon client 4.3.10 to local mode i.e. allow
> client to do the proc check locally and I keep getting this error****
>
> ** **
>
> bin/xymonclient.sh: ./bin/xymond_client: not found****
>
> ** **
>
> Can anybody please assist****
>
> ** **
>
> Thank you****
>
> ** **
>
> *Kemi Ariyo*
>
> *IS Solutions plc*
>
> *Switchboard: 01932-893333*
>
> *Direct: 01932-893327*
>
> *Fax: 01932-893433*
>
> *Mobile: *
>
> *http://www.issolutions.co.uk*
>
> ** **
>
> ------------------------------
> Disclaimer:
>
> This message is intended for the addressee only. It may contain
> information of a confidential or legally privileged nature. If you have
> received this message in error please notify the sender and destroy the
> message immediately. All attachments have been scanned for viruses. However
> IS Solutions plc cannot accept liability for any loss or damage you may
> incur as a result of virus infection.
>
> _______________________________________________
> Xymon mailing list
> Xymon at xymon.com
> http://lists.xymon.com/mailman/listinfo/xymon
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.xymon.com/pipermail/xymon/attachments/20120914/67058439/attachment.html>