[hobbit] host-specific settings

[Morris, Chris (SS-IS)]

You need to put the server specific entry(ies) BEFORE the default settings.


  _____  

From: Johan Booysen [mailto:johan at matrix-data.co.uk] 
Sent: 08 August 2008 11:34
To: hobbit at hswn.dk
Subject: [hobbit] host-specific settings



I'm new to hobbit monitor, and trying to set up host-specific settings in
hobbit-clients.cfg on the hobbit server.  At the moment I want to do a
simple test, so that default settings apply to all clients except for
server1 for which I want to use other disk space parameters:

 

In hobbit-clients.cfg I have:

 

DEFAULT

        # These are the built-in defaults.

        UP      1h

        LOAD    5.0 10.0

        DISK    * 90 95

        MEMPHYS 100 101

        MEMSWAP 50 80

        MEMACT  90 97

 

HOST=server1

 DISK    * 95 99

 

However, server1 still applies the default settings for DISK.  I've reloaded
the hobbit service so it rereads its config files, but after about 30
minutes the changes still don't seem to have taken effect.

 

I've followed the instructions on the hobbit-config.html help page, but
think I may be missing something.

 

Any advice on this?

 

Thanks. 

 


**********************************************************************
This e-mail including any attachments is provided for general information purposes only and does not constitute advice except to the addressee if expressly stated in this email. For the avoidance of doubt the contents of this email and any attachments are subject to contract and are not intended to and will not constitute a legally binding contract or any part of a legally binding contract. 

The information contained in this email and any attachments is confidential.  It is intended only for the use of the intended recipient at the email address to which it has been addressed. If the reader of this message is not an intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination, distribution or copying of the message or associated attachments is strictly prohibited.

If you have received this e-mail in error, please notify postmaster at RWEsystemsUK.com and permanently delete the email and any attachments immediately from your system.  You should not retain, copy or use this email or any attachment for any purpose, nor disclose all or any part of the contents to any other person.  Thank you for your co-operation. 

Neither RWE IT UK Ltd nor any of the other companies in the RWE Group from whom this e-mail originates accept any responsibility for losses or damage as a result of any viruses and it is your responsibility to check attachments (if any) for viruses. 

RWE IT UK Ltd Registered office: Mistral, Westlea Campus, Chelmsford Road, Swindon, Wiltshire, SN5 7EZ. Registered in England and Wales: company number 6052966.

*******************************************

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.xymon.com/pipermail/xymon/attachments/20080808/6220346c/attachment.html>