RE: [xymon] RE: xymon test dependencies

["Taylor Lewick" <tlewick (at) tradebotsystems.com>]

OK, thanks, any opinions on whether it is better to use route, or depends?

-----Original Message-----
From: Johan Sjöberg [mailto:johan.sjoberg (at) deltamanagement.se] 
Sent: Wednesday, October 13, 2010 12:34 PM
To: xymon (at) xymon.com
Subject: [xymon] RE: xymon test dependencies

Hi.

Use the "route" setting. For each connected device, add "route:switch.company.com". That way, if the conn test of the switch fails, any conn test for the connected devices will go yellow instead of red.

/Johan

-----Original Message-----
From: Taylor Lewick [mailto:tlewick (at) tradebotsystems.com] 
Sent: den 13 oktober 2010 18:01
To: xymon (at) xymon.com
Subject: [xymon] xymon test dependencies

From the xymon.com webpage is this snippit...

---
Combined super-tests and test interdependencies ...
    Tests can also be configured to depend on each other, so that when a critical router goes down you will get alerts only for the router - and not from the 200 hosts behind the router.
---

I'm not seeing how to set this type of testing up, basically event correlation, so that if a switch goes down, hobbit knows not to send alerts for each connected host.

Can some point me in the right direction, i.e. specific man-page, or just show me an example of how to configure this?

Thanks,
Taylor

To unsubscribe from the xymon list, send an e-mail to xymon-unsubscribe (at) xymon.com



To unsubscribe from the xymon list, send an e-mail to
xymon-unsubscribe (at) xymon.com