[hobbit] host-specific settings

[Johan Booysen]

Thanks for the replies.  Next time I'll read through the WHOLE man page
before asking a  question!

 

J

 

From: Morris, Chris (SS-IS) [mailto:Chris.Morris at RWEsystemsUK.com] 
Sent: 08 August 2008 11:47
To: hobbit at hswn.dk
Subject: RE: [hobbit] host-specific settings

 

 

You need to put the server specific entry(ies) BEFORE the default
settings.

________________________________

From: Johan Booysen [mailto:johan at matrix-data.co.uk] 
Sent: 08 August 2008 11:34
To: hobbit at hswn.dk
Subject: [hobbit] host-specific settings

I'm new to hobbit monitor, and trying to set up host-specific settings
in hobbit-clients.cfg on the hobbit server.  At the moment I want to do
a simple test, so that default settings apply to all clients except for
server1 for which I want to use other disk space parameters:

 

In hobbit-clients.cfg I have:

 

DEFAULT

        # These are the built-in defaults.

        UP      1h

        LOAD    5.0 10.0

        DISK    * 90 95

        MEMPHYS 100 101

        MEMSWAP 50 80

        MEMACT  90 97

 

HOST=server1

 DISK    * 95 99

 

However, server1 still applies the default settings for DISK.  I've
reloaded the hobbit service so it rereads its config files, but after
about 30 minutes the changes still don't seem to have taken effect.

 

I've followed the instructions on the hobbit-config.html help page, but
think I may be missing something.

 

Any advice on this?

 

Thanks. 

 

**********************************************************************

This e-mail including any attachments is provided for general
information purposes only and does not constitute advice except to the
addressee if expressly stated in this email. For the avoidance of doubt
the contents of this email and any attachments are subject to contract
and are not intended to and will not constitute a legally binding
contract or any part of a legally binding contract. 

 

The information contained in this email and any attachments is
confidential. It is intended only for the use of the intended recipient
at the email address to which it has been addressed. If the reader of
this message is not an intended recipient, you are hereby notified that
you have received this document in error and that any review,
dissemination, distribution or copying of the message or associated
attachments is strictly prohibited.

 

If you have received this e-mail in error, please notify
postmaster at RWEsystemsUK.com and permanently delete the email and any
attachments immediately from your system. You should not retain, copy or
use this email or any attachment for any purpose, nor disclose all or
any part of the contents to any other person. Thank you for your
co-operation. 

 

Neither RWE IT UK Ltd nor any of the other companies in the RWE Group
from whom this e-mail originates accept any responsibility for losses or
damage as a result of any viruses and it is your responsibility to check
attachments (if any) for viruses. 

 

RWE IT UK Ltd Registered office: Mistral, Westlea Campus, Chelmsford
Road, Swindon, Wiltshire, SN5 7EZ. Registered in England and Wales:
company number 6052966.

 

*******************************************

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.xymon.com/pipermail/xymon/attachments/20080808/23f35df7/attachment.html>