[hobbit] How to configure Clients

[Jones, Jason (Altrincham)]

First make sure the clients are reporting to your server (should have asked you the IP address when you compiled the clients.

As for hobbit-clients you can do the configurations for each server if you wish by using the following:

HOST=host1, host2
	DISK	90	95
	PROC	ccApp.exe	1
	MEMPHYS	99	100

HOST=host3
	DISK	80	90

DEFAULT
	UP      1h
      LOAD    5.0 10.0
      DISK    %^(/vob|/cdrom).* IGNORE
      DISK    %^/(mnt|tap).* IGNORE
      DISK    * 90 95
      MEMPHYS 100 101
      MEMSWAP 50 80
      MEMACT  90 97


-----Original Message-----
From: Christian Rehberger [mailto:c.rehberger at oclcpica.org] 
Sent: 22 September 2006 12:35
To: hobbit at hswn.dk
Subject: [hobbit] How to configure Clients

Hello,

I'm using hobbit since mondy this week and now I run in problems how 
to configure various checks on various clients.

Ok, I built a hobit server sucsessfully. The network tests works all 
fine.

But now I have to check disk space and procs on two other machines.
I've installed the client on each machine but I cannot configure the 
warnlevel or paniclevel of these clients or procs at all.

It seems, that only entries in the server located file 
"hobbit-clients.cfg" takes care?

My problem is, that I have to use different levels on each client 
machine!

Whats wrong with my configuration?

Thankx

Chris

-- 
Christian Rehberger
System Consultant · OCLC PICA GmbH
Grünwalder Weg 28g · 82041 Oberhaching · Germany
t +49-(0)89-61308 333 · f +49-(0)89-61308 399 
e c.rehberger at oclcpica.org · w http://www.oclcpica.org

To unsubscribe from the hobbit list, send an e-mail to
hobbit-unsubscribe at hswn.dk