[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [hobbit] How to configure Clients
- To: <hobbit (at) hswn.dk>
- Subject: RE: [hobbit] How to configure Clients
- From: "Jones, Jason \(Altrincham\)" <JasonAS_Jones (at) mentor.com>
- Date: Fri, 22 Sep 2006 12:41:03 +0100
- Thread-index: AcbeO1F4BVAai0hIQDK+BhLhwbGwkwAADRtg
- Thread-topic: [hobbit] How to configure Clients
First make sure the clients are reporting to your server (should have asked you the IP address when you compiled the clients.
As for hobbit-clients you can do the configurations for each server if you wish by using the following:
HOST=host1, host2
DISK 90 95
PROC ccApp.exe 1
MEMPHYS 99 100
HOST=host3
DISK 80 90
DEFAULT
UP 1h
LOAD 5.0 10.0
DISK %^(/vob|/cdrom).* IGNORE
DISK %^/(mnt|tap).* IGNORE
DISK * 90 95
MEMPHYS 100 101
MEMSWAP 50 80
MEMACT 90 97
-----Original Message-----
From: Christian Rehberger [mailto:c.rehberger (at) oclcpica.org]
Sent: 22 September 2006 12:35
To: hobbit (at) hswn.dk
Subject: [hobbit] How to configure Clients
Hello,
I'm using hobbit since mondy this week and now I run in problems how
to configure various checks on various clients.
Ok, I built a hobit server sucsessfully. The network tests works all
fine.
But now I have to check disk space and procs on two other machines.
I've installed the client on each machine but I cannot configure the
warnlevel or paniclevel of these clients or procs at all.
It seems, that only entries in the server located file
"hobbit-clients.cfg" takes care?
My problem is, that I have to use different levels on each client
machine!
Whats wrong with my configuration?
Thankx
Chris
--
Christian Rehberger
System Consultant · OCLC PICA GmbH
Grünwalder Weg 28g · 82041 Oberhaching · Germany
t +49-(0)89-61308 333 · f +49-(0)89-61308 399
e c.rehberger (at) oclcpica.org · w http://www.oclcpica.org
To unsubscribe from the hobbit list, send an e-mail to
hobbit-unsubscribe (at) hswn.dk