[Xymon] Xymon server reporting to itself and another Xymon server

Gore, David W (David) david.gore at verizon.com
Wed Nov 14 16:30:50 CET 2012


I was using something similar to what Eric was using.  Nice to know this exists, trying it now, enabled in tasks.cfg.  Perhaps xymond distribute was added in 4.3.10 or an earlier version and I was not paying attention. Nice!  Thanks Henrik.

-----Original Message-----
From: xymon-bounces at xymon.com [mailto:xymon-bounces at xymon.com] On Behalf Of henrik at hswn.dk
Sent: Wednesday, November 14, 2012 07:23
To: xymon at xymon.com
Subject: Re: [Xymon] Xymon server reporting to itself and another Xymon server

On Fri, 9 Nov 2012 10:39:43 -0600, Eric Thiele <ethiele at gmail.com> wrote:
> Server A
> Server B
> When I use the CGI to Enable / Disable alerts...  I am only enabling /
> disabling on the server I'm viewing.
> I'm using http://<server IP>/hobbit-seccgi/enadis.sh
> 
> How do I make my single enable / disable action propagate to both
servers?

Use the xymond_distribute module on your main server - using it on both is
not recommmended, since you will probably end up with a forwarding loop.


Regards,
Henrik

_______________________________________________
Xymon mailing list
Xymon at xymon.com
http://lists.xymon.com/mailman/listinfo/xymon



More information about the Xymon mailing list